Bimini Installation Height
-
nolaboater99
- Captain

- Posts: 408
- Joined: Wed Feb 14, 2018 9:34 pm
- Location: Covington, LA
- Contact:
Bimini Installation Height
Guys,
I am getting ready to install a bimini on the boat. This boat has never had one on it nor has it ever had a top on it of any kind, just covers.
I bought A really nice one from National Covers and my choices were 36" or 46" high. I measured it 6 ways from Sunday and decided the 36" would be too low but I was afraid the 46" would be too tall. The original place to mount a bimini on this model was inside the windshield....kinda weird. I'm planning to mount it outside but at my lowest mount point the top would be 9" above my head when I'm standing at the helm....I'm 6' 2".
I want this to look good and I don't want it to look like some towering appendage over the boat but I had a boat once that the top was not high enough. Here is the question. How high over your head is your bimini top? Or maybe how high over your windshield is the top? Or any other advice you wish to offer will be appreciated.
Thanks
Shawn
I am getting ready to install a bimini on the boat. This boat has never had one on it nor has it ever had a top on it of any kind, just covers.
I bought A really nice one from National Covers and my choices were 36" or 46" high. I measured it 6 ways from Sunday and decided the 36" would be too low but I was afraid the 46" would be too tall. The original place to mount a bimini on this model was inside the windshield....kinda weird. I'm planning to mount it outside but at my lowest mount point the top would be 9" above my head when I'm standing at the helm....I'm 6' 2".
I want this to look good and I don't want it to look like some towering appendage over the boat but I had a boat once that the top was not high enough. Here is the question. How high over your head is your bimini top? Or maybe how high over your windshield is the top? Or any other advice you wish to offer will be appreciated.
Thanks
Shawn
1985 Cobalt CM23
383 Stroker GM Small Block
383 Stroker GM Small Block
Re: Bimini Installation Height
I don't have easy access to my boat or I would measure it for you. From looking at pics online of folks standing under the open bimini, there looks to be about a foot clearance above their heads (or more). On my 232, the mounts look to be centered on the top stripe, if this helps. Due to that position, it looks like it belongs on the boat. Pic attached.
You do not have the required permissions to view the files attached to this post.
2010 Cobalt 232 8.1Gi
- Big Block Power
- Fleet Admiral

- Posts: 17930
- Joined: Sat May 07, 2016 8:05 pm
- Location: Neenah,Wi
- Contact:
Re: Bimini Installation Height
I was going to say about 6.5 - 7 feet from the floor might be good. I'm 5.7 and Yt is 5.1 and we each already have 2 feet above our heads. Lol
Mine goes to the top of my tower. The gr81 has plenty of room.
Mine goes to the top of my tower. The gr81 has plenty of room.
You do not have the required permissions to view the files attached to this post.
03Cobalt220 8.1gxi DP
"Kids in Tow2"
"Pot The Jus" Originator :-)
Neenah Wi
#ItsBu'sfault
#FARCON Marine CC Core!
"Kids in Tow2"
"Pot The Jus" Originator :-)
Neenah Wi
#ItsBu'sfault
#FARCON Marine CC Core!
- thunder550
- Vice Admiral

- Posts: 2246
- Joined: Sun Oct 08, 2017 2:16 pm
- Location: Scottsdale, AZ
- Contact:
Re: Bimini Installation Height
Mine's probably a foot or so above my head. I like it that way. Other boats we've had have not been that tall and we've had to crouch down a bit under the bimini.
You do not have the required permissions to view the files attached to this post.
1995 Cobalt 252 - 502 Mag EFI - Bravo 1 - 21" Revolution 4
Re: Bimini Installation Height
I'm 6'1" and have no problem standing under the bimini on my boat.
You do not have the required permissions to view the files attached to this post.
2018 r5
2003 220
2003 220
Re: Bimini Installation Height
The only way BB is 5'7" is if he's setting on A7's shoulders. And everything, including biminis, is way over his head! 
Shawn mine has plenty of clearance. If you set it up 6 or so inches above your head you should be fine. And I'd run the leading edge just forward of the windshield.
Shawn mine has plenty of clearance. If you set it up 6 or so inches above your head you should be fine. And I'd run the leading edge just forward of the windshield.
You do not have the required permissions to view the files attached to this post.
2001 262 502 GXI (because it sounds better than an 8.2)
From the Land of the Red Man
"Black Boats Matter"
#FARCON Marine / CC Core!
From the Land of the Red Man
"Black Boats Matter"
#FARCON Marine / CC Core!
- Big Block Power
- Fleet Admiral

- Posts: 17930
- Joined: Sat May 07, 2016 8:05 pm
- Location: Neenah,Wi
- Contact:
Re: Bimini Installation Height
So now you're calling A7 short. Coming from a guy that's 5.1 yea 6 feet is good. LolYtmsn wrote: Fri Jul 13, 2018 10:13 pm The only way BB is 5'7" is if he's setting on A7's shoulders. And everything, including biminis, is way over his head!
Shawn mine has plenty of clearance. If you set it up 6 or so inches above your head you should be fine. And I'd run the leading edge just forward of the windshield.
20180701_185146.jpg
03Cobalt220 8.1gxi DP
"Kids in Tow2"
"Pot The Jus" Originator :-)
Neenah Wi
#ItsBu'sfault
#FARCON Marine CC Core!
"Kids in Tow2"
"Pot The Jus" Originator :-)
Neenah Wi
#ItsBu'sfault
#FARCON Marine CC Core!
-
Islander208
- Commander

- Posts: 198
- Joined: Mon May 21, 2018 9:40 pm
- Location: San Antonio
- Contact:
Re: Bimini Installation Height
I'm 6'2" as well. I just measured: the top of the tower is about 83" to the floor. About 9" clearance. Also, floor to the top of the windshield is about 45". Hope this helps.
You do not have the required permissions to view the files attached to this post.
Last edited by Islander208 on Fri Jul 13, 2018 10:38 pm, edited 1 time in total.
2004 220
6.2 MPI B3
Yellow/Blk/Wht
San Antonio; Medina/Canyon Lakes
6.2 MPI B3
Yellow/Blk/Wht
San Antonio; Medina/Canyon Lakes
Re: Bimini Installation Height
Nola, be careful.. A7, BB and YT. are not the guys to ask about height..
You do not have the required permissions to view the files attached to this post.
2017 Cobalt R7
"Cobalt" Blue
6.2L VP 380 or 430
#FARCON Marine
"Cobalt" Blue
6.2L VP 380 or 430
#FARCON Marine
- Big Block Power
- Fleet Admiral

- Posts: 17930
- Joined: Sat May 07, 2016 8:05 pm
- Location: Neenah,Wi
- Contact:
Re: Bimini Installation Height
Thanks for giving us upTuscany wrote: Fri Jul 13, 2018 10:35 pm Nola, be careful.. A7, BB and YT. are not the guys to ask about height..![]()
My tower is a few inches shorter due to my garage. Lol
Too soon.
03Cobalt220 8.1gxi DP
"Kids in Tow2"
"Pot The Jus" Originator :-)
Neenah Wi
#ItsBu'sfault
#FARCON Marine CC Core!
"Kids in Tow2"
"Pot The Jus" Originator :-)
Neenah Wi
#ItsBu'sfault
#FARCON Marine CC Core!
Re: Bimini Installation Height
2001 262 502 GXI (because it sounds better than an 8.2)
From the Land of the Red Man
"Black Boats Matter"
#FARCON Marine / CC Core!
From the Land of the Red Man
"Black Boats Matter"
#FARCON Marine / CC Core!
Re: Bimini Installation Height
Nola I’m not sure there is a perfect Bimini. Proportional is in the eye . I’m still seeing yours as a drop down type the although flimsy with straps , it won’t kill the lines of your beauty.
I have 7 feet.. it will be up all weekend
2008 272 , 496 HO fo SHO
California Delta
Table Rock Lake
#FARCON
California Delta
Table Rock Lake
#FARCON
Re: Bimini Installation Height
Is there a stock Cobalt option available?
I love LOVE the design. It goes up in literally seconds, folds flat to store, and made from heavy round stainless.
The key and most important part is that it is totally silent. Never a rattle no matter the conditions. The forward tubes have two threaded ends where you can turn the tube and torque down the entire structure.
After market systems?
The outsource producer is http://www.makefast.com/ from the UK.
I love LOVE the design. It goes up in literally seconds, folds flat to store, and made from heavy round stainless.
The key and most important part is that it is totally silent. Never a rattle no matter the conditions. The forward tubes have two threaded ends where you can turn the tube and torque down the entire structure.
After market systems?
The outsource producer is http://www.makefast.com/ from the UK.
You do not have the required permissions to view the files attached to this post.
2017 Cobalt R7
"Cobalt" Blue
6.2L VP 380 or 430
#FARCON Marine
"Cobalt" Blue
6.2L VP 380 or 430
#FARCON Marine
-
nolaboater99
- Captain

- Posts: 408
- Joined: Wed Feb 14, 2018 9:34 pm
- Location: Covington, LA
- Contact:
Re: Bimini Installation Height
Thanks for the quick responses Guys. Your comments and pictures really help. I think the one I have will be fine.
A7, YT & BB not sure what to tell you other than you would all like my wife....5" 0"
A7, YT & BB not sure what to tell you other than you would all like my wife....5" 0"
1985 Cobalt CM23
383 Stroker GM Small Block
383 Stroker GM Small Block
- AsLan7
- Fleet Admiral

- Posts: 11526
- Joined: Sat Jul 29, 2017 10:58 am
- Location: Erie PA
- Has thanked: 1 time
- Been thanked: 6 times
- Contact:
Re: Bimini Installation Height
nolaboater99 wrote: Sat Jul 14, 2018 6:21 pm Thanks for the quick responses Guys. Your comments and pictures really help. I think the one I have will be fine.
A7, YT & BB not sure what to tell you other than you would all like my wife....5" 0"
Tuscany wrote: Fri Jul 13, 2018 10:35 pm Nola, be careful.. A7, BB and YT. are not the guys to ask about height..![]()
.
2002 Cobalt 262
&
2005 Cobalt 263
496 MagHO
(sold )
Erie, PA
Currently boatless (for now)
will fly for food
(CChat moderator)
&
2005 Cobalt 263
496 MagHO
(sold )
Erie, PA
Currently boatless (for now)
will fly for food
(CChat moderator)
Who is online
Users browsing this forum: Ahrefs [Bot], Bing [Bot] and 154 guests
