Rgb courtesy light

[Big Block Power]

Ok I've been looking for some time a replacement light or a bulb for my floor courtesy light. I have 3 of them. I want to switch over to a rgb led light. So it has to have the red green blue black wire going to it. All I can find is 2 wire led bulbs. The bulbs in mine are not replaceable. But I can drill a hole in the back side if needed to add a bulb and socket. Now it's a 3x1 light the other issue why I can't go with a round one is the one in the bow they mounted it vertically. There's not much of a flat spot up there. I can't go with a smaller one or the screw holes will show. I found smaller ones but they won't work. Here is what I have and what won't work. The picture with the 3 colored lights are too small. I wish they would work but that's what I'm looking for.

[Big Block Power]

Hey BBP I found this today
I know you still rather have the complete light but this will be a good back up plan.

[NautiGirl]

And this is hilarious. I sure hope BB sees that BB found his light for him. Good find! LOL

[AsLan7]

We shall put away the bat signal then.

[Big Block Power]

Hey thanks BBP You shouldn't take so long to reply. As Nauti says free advice takes some time you know.
Thanks for finding that now I hope you can find a complete light. I'll wait patiently while you search for me.
Next time Aslan will send the bat signal to let me know I have a part to find. Sorry for the delay. Sincerely BBP

[cmattj]

This RV lighting company may have want you want..
The down lights come in stainless..

http://www.itc-rv.com/

[Big Block Power]

This RV lighting company may have want you want..
The down lights come in stainless..

http://www.itc-rv.com/

Yes thanks that's the one I was going to with. But it's just under 2 inches long. It's the same as the one I have in the picture.

[thunder550]

BBP to the rescue!

4749aa7fa0200e64604c5c8f1157e14d.jpg

[Big Block Power]

That's funny right there.lol

[Big Block Power]

Well BBP I think I know what your problem is with that light. The black wire looks like it came off the resistor going to the led. So I think if you Change it over to that single rgb led that should work. I have no idea why they couldn't put a bulb and socket set up in this assembly like they did in 2004?
Thanks BBP for your thoughts.