Cobalt 232 Underwater Lights Pictures?

[spen5151]

Hello, does anyone out there happen to have pictures of underwater lights that were installed at the factory when the boat was ordered? If so you you mind sharing? Also, if you have an aftermarket set installed and wouldn’t mind sending pictures that would be great. I’m looking for pictures of the transom standing behind the boat while it is out of the water if possible. I am installing a set of lumitecs and I am trying to decide the best location. I believe factory install is to the direct left and right of the drive on the transom.

[spen5151]

Installed my lights this past weekend. Thought I would share a picture. From what I could tell this is very close to where the factory installed underwater lights on the 232. It’s the flattest part of the transom and I was able to get them low enough under the waterline. Excited to see how they look this weekend.

[AsLan7]

Looking good spen5151
Yes be sure to post an underwater pic.

[dsthomas]

Don't know if this helps ya, but here is a pick of our R7 surf with them. They are cool and everything, but if I had to delete something from my boat due to affordability, they'd be the first thing on the list.

[dsthomas]

Here it is on the trailer, we ordered it from the factory with them.

[Big Block Power]

I like that protection cover they added to the surf drive!
Lights look great.

[spen5151]

Here it is on the trailer, we ordered it from the factory with them.

Thank you for posting, I ended up mounting mine in about the same spot. Will grab a in water picture this weekend hopefully and post.

[DeadOn04]

Here it is on the trailer, we ordered it from the factory with them.

Thank you for posting, I ended up mounting mine in about the same spot. Will grab a in water picture this weekend hopefully and post.

I’m about to install the Lumitecs on my boat this weekend. Was your placement good or any gotchas? Any action shots? Thanks!

[DeadOn04]

Figured I’d follow up. I ran out of time so decided just to have them installed by a local shop. The tech convinced me to place them outside the stern drive cavity because the extended running surface blocks the light from radiating laterally. I’m very happy with the results. I went with the blue/white combo Seablaze X2 from lumitec. They have thermal protection to keep them from overheating, so t require a separate controller and pack a 6000 lumen punch for a reasonable price.

[AsLan7]

.
Gorgeous. Nice follow up. Thanks for doing that Do4!

[Krob1114]

When we decide to go with aftermarket under water lighting, we'll probably use the one that replaces the drain plug. Don't have to cut holes.
There's a thread here somewhere with pics and final results were great.

[Big Block Power]

When we decide to go with aftermarket under water lighting, we'll probably use the one that replaces the drain plug. Don't have to cut holes.
There's a thread here somewhere with pics and final results were great.

Here is mine. I should have waited till it was a bit darker.