Upholstery Replacement

Post Reply
RobT
Ensign
Ensign
Posts: 6
Joined: Mon Aug 26, 2019 10:05 am
Location: Lake Conroe, TX
Contact:

Upholstery Replacement

Post by RobT »

I realize that this is very regional-specific, but what have people experienced for cost to replace upholstery? I'm looking at a 262 that hasn't been cared for cosmetically for a couple of years. It has sat open and exposed, and while it doesn't have cracked/torn upholstery yet, it probably will need to be replaced in the very near future. The boat is priced accordingly for the gelcoat and cleanliness, but I'm trying to calculate my purchase and restoration costs against typical resale. It's a 2003 262 with a new (block only) VP 8.1Gi with DP-SM drive and Captains Call exhaust.
2009 Cobalt 242 (5.7 GxI-J)
Sold Boats
2003 Formula 37P (twin Merc 8.1 HO w/ V-drives)
2004 Cobalt 282 (twin VP 5.0 GxI)
2000 Hunter 380 (Yanmar 3JH-2E)
2000 Chaparral Signature 270 (VP 8.1 GxI-E)
2002 Monterey 190 (Merc 5.0 w/A1g2)
User avatar
jhnmdahl
Vice Admiral
Vice Admiral
Posts: 2377
Joined: Tue Jan 06, 2015 5:11 pm
Location: Twin Cities, MN
Has thanked: 2 times
Been thanked: 1 time
Contact:

Re: Upholstery Replacement

Post by jhnmdahl »

You're looking at $3k-$4k or so for a full re-upholstery, assuming the shop can use the old upholstery as a "template" for what they need to make. I've heard of people getting a boat done for $2k, but that's the exception I think. If you're creeping up toward 30', you can be well over $5k.

Keep in mind that foam may need to be replaced too, as it has a finite life and loses resilience over time. A good shop's bid should tell you things like foam density, vinyl weight, and other characteristics, etc. - it just doesn't make sense to skimp on materials for a project like this.

Heavier vinyl is usually, but not always, better - see https://www.marinevinylfabric.com/blogs ... rine-vinyl
and good vinyl will tell you lots about its construction, wear resistance, UV treatment, etc, like: https://www.omnova.com/detail-1-1?ai%5B ... egion=AMER
Administrator of the www.cobaltchat.com Cobalt boats community forum
2015 210 (Volvo Penta 5.7L V8-225)
CBO
Commander
Commander
Posts: 168
Joined: Mon May 25, 2020 10:46 am
Location: Idaho
Contact:

Re: Upholstery Replacement

Post by CBO »

I guess the East Coast is much cheaper than the West Coast. I've been quoted 10k-12k for a complete interior and that is for me to remove and reinstall all the pieces. A buddy just had the captain chairs redone and that alone was a little over 2k + the Sliderule kits. I wish I could find someone that will do it for 4k. The issue that I am running into is quality of work, it seems that there is no one out there that can produce Cobalt factory quality interior work. With Cobalt changing their ways with this buy out, the interior employees should open up shop. I would not bat an eye to send all my interior to them to have it done right. They'd make a killing. I personally would get quotes before making an offer. Keep in mind that if it has the swivel Captains chairs guarantee the plastic bottoms are broken and will need the Sliderule Racing kits, another 450 + labor. Then you have carpet on top of that, I just spent 725 at Corinthians for new carpets.
2007 Cobalt 222 (Sold)
Rathdrum, ID
User avatar
kbloom72
Commander
Commander
Posts: 168
Joined: Mon May 21, 2018 11:44 am
Location: Chicago
Contact:

Re: Upholstery Replacement

Post by kbloom72 »

I just had the entire bow, the lower section of the rear horseshoe (anything your butt goes on) and the sun platforms done on my 05 262. It was $5800. We spent a lot of time working to make sure the vinyl matched really well. I'm in Northern Illinois.
2005 Cobalt 262
Fox River Grove, IL
Aewillis
Ensign
Ensign
Posts: 1
Joined: Mon Jun 10, 2024 5:22 am
Location: Chicago
Contact:

Re: Upholstery Replacement

Post by Aewillis »

Kbloom where did you get your upholstery done? We're looking to have our sun pad done and are in Wauconda. 2000 262.
User avatar
AsLan7
Fleet Admiral
Fleet Admiral
Posts: 11463
Joined: Sat Jul 29, 2017 10:58 am
Location: Erie PA
Been thanked: 1 time
Contact:

Re: Upholstery Replacement

Post by AsLan7 »

Aewillis wrote: Sat Feb 22, 2025 7:41 am Kbloom where did you get your upholstery done? We're looking to have our sun pad done and are in Wauconda. 2000 262.
.
So glad you found us Aewillis. The 262 is an amazing machine. Upholstery replacement can be a challenge especially with the side gunwales but hopefully the installer you find in the area can handle that. It’s well worth the upgrade as this is the one major issue of older 262’s. Most other items on the 262 can be sourced.

Any pics? How is she powered?
And welcome aboard mate.

.
You do not have the required permissions to view the files attached to this post.
2002 Cobalt 262
&
2005 Cobalt 263
496 MagHO
(sold )
Erie, PA
Currently boatless (for now)
will fly for food

(CChat moderator)
Post Reply

Who is online

Users browsing this forum: No registered users and 39 guests