Cobaltchat.com

Ok I've been looking for some time a replacement light or a bulb for my floor courtesy light. I have 3 of them. I want to switch over to a rgb led light. So it has to have the red green blue black wire going to it. All I can find is 2 wire led bulbs. The bulbs in mine are not replaceable. But I can drill a hole in the back side if needed to add a bulb and socket. Now it's a 3x1 light the other issue why I can't go with a round one is the one in the bow they mounted it vertically. There's not much of a flat spot up there. I can't go with a smaller one or the screw holes will show. I found smaller ones but they won't work. Here is what I have and what won't work. The picture with the 3 colored lights are too small. I wish they would work but that's what I'm looking for.

Hey BBP I found this today
I know you still rather have the complete light but this will be a good back up plan.

And this is hilarious. I sure hope BB sees that BB found his light for him. Good find! LOL

We shall put away the bat signal then.

Hey thanks BBP You shouldn't take so long to reply. As Nauti says free advice takes some time you know.
Thanks for finding that now I hope you can find a complete light. I'll wait patiently while you search for me.
Next time Aslan will send the bat signal to let me know I have a part to find. Sorry for the delay. Sincerely BBP

This RV lighting company may have want you want..
The down lights come in stainless..

http://www.itc-rv.com/

cmattj wrote: Sun Nov 19, 2017 7:17 pm This RV lighting company may have want you want..
The down lights come in stainless..

http://www.itc-rv.com/

Yes thanks that's the one I was going to with. But it's just under 2 inches long. It's the same as the one I have in the picture.

BBP to the rescue!

That's funny right there.lol

Well BBP I think I know what your problem is with that light. The black wire looks like it came off the resistor going to the led. So I think if you Change it over to that single rgb led that should work. I have no idea why they couldn't put a bulb and socket set up in this assembly like they did in 2004?
Thanks BBP for your thoughts.