Cobaltchat.com

Hey there. One of the connectors for my bimini top has been bent (see photo). Does anyone know where I can get a replacement and how I would remove the old one and replace the new one? Or if that is not the best way to fix this then what is? Thanks!

Generally those fittings are just pressed into the tubing. However, it looks like that one is held in place by that crimp you see around the tube. Getting it out could be a challenge without damaging the tubing. I would put the eye end that is bent in a vice and give it a try. Also worth a try to straighten it while it's in the vice - pad it up so the vice doesn't damage it. As far as a replacement, should be able to find it from Taylor Made - it's called an internal eye end.
I replaced all the bimini hardware on my old boat - it was aluminum and all the fittings were nylon - it was a real PIA to remove all of those inside eyes.

Contact a business in your area that does boat covers. or try searching Bimini top parts. I destroyed two bimini tops because of a low bridge. That bridge has since been been replaced.

Thanks for the help! I'll give the vice a try and then contact local businesses.

SAB220 wrote: Sun Jul 30, 2023 6:14 pm Contact a business in your area that does boat covers. or try searching Bimini top parts. I destroyed two bimini tops because of a low bridge. That bridge has since been been replaced.

Bridge replaced.