Cobaltchat.com

Has anyone replaced the push in rubber bumpers for the stern cooler lid yet? I have a 2003 220 center walk through.they look like these

After removing and measuring the old bumpers I was able to source them through McMaster Carr.

Is that the same P/N above as you state above... any picture of existing??

I pickup some to have on hand

This is what I ordered for the stern cooler it requires 2 of these. I also have three different sizes of bumpers for the walk through doors the bumper compartments the anchor locker and ski locker. I ordered these I’ll post back after installation with review.

Thanks, my boat is wrapped for the winter can't see

Nice info. What is a stern cooler? Is it the same as the small wet locker on my upper swim platform?

I had found the 9309K16 bumpers on my ski locker this summer, but never got around to posting about it.

The 9504K42 and 9504K672 rubber bumpers are identical in size and only slightly different in shape. The 9504K42 bumpers are everywhere on my boat - bow walkthrough doors, stern walkthrough hatch, anchor locker hatch, swim platform wet locker, and in-deck table storage.

Where are the 9504K672 bumpers used on your boat? I don’t seem to have any of those, but it may be that I just haven’t looked hard enough.

Hmm wet locker learn something new every day. Works as a water cooler also. 9504K672 Are under the bumper storage compartment latching lids.