Cobaltchat.com

Looking to see if anyone knows what the change in bridge clearance is with the Manuel folding tower down? My boats in storage and I’m building a new garage hoping I don’t have to go measure. Thanks for any reply

Robm wrote: Thu Nov 12, 2020 8:38 pm Looking to see if anyone knows what the change in bridge clearance is with the Manuel folding tower down? My boats in storage and I’m building a new garage hoping I don’t have to go measure. Thanks for any reply

.
Hey Robm. Welcome to the Cobaltchat forum. So glad you found us!

Can’t help you with your question but I’m sure someone here will chime in with a measurement.

Any pics? How is she powered?

Again welcome aboard mate!

.

Here is the boat if anyone can help:) 2019 R7 Surf 430hp

Good luck on your quest. I tried many different times with people at Cobalt and dealer itself to find that measurement. You will have to measure it yourself, is what I was told by them. We ended up not ordering a tower - wasn't going to take the chance it wouldn't fit.

What a frecken beast! Loce it!
Or just do what Tuscany did, build the garage for high enough with the tower binimi up no worries

I have a 2018 R7 Surf with the same tower but is power folding. I recently built a barn for it and it fits without lowering in my 12ft OH doors by about an inch. Your trailer could affect that for the better or worse I don't know. Mine fits in a 10ft OH door with the tower lowered.

Thank you that was the answer I was after, I did get down to the dealer and measured how much clearance you gain with tower folded. Two feet exactly on a r3 I know my boat fits under a 12 with tower up so I feel good about folded in a 10ft.