Cobaltchat.com

When I turn on blower, the trim gauge and other gauges goes off, I turn blower off they come on.

2016 26 sd wss with volvo 380

thanks

Wouldn’t this be a warranty claim?

Yea to me sounds like a loose grd somewhere.

Big Block Power wrote: Tue Nov 27, 2018 7:12 pm Yea to me sounds like a loose grd somewhere.

Yes as gauges share common grounds that bridge between them. Get to lossen ...then tighten them down.

201626sdwss wrote: Tue Nov 27, 2018 5:42 pm when i turn on blower the trim gage and other gages goes off , i turn blower off they come on

2016 26 sd wss with volvo 380

thanks

Hey, welcome to the CobaltChat forum 201626sdwss......so glad you found us!

Any pics of your baby? Is this your first Cobalt?

Look under the dash and see if there are any loose wires. Like the others have mentioned, you most likely have a loose ground (normally black) wire that just needs tightened. When you turn on the blower, the circuit is trying to complete by grounding out elsewhere like your gauges (which shorts the circuit). First check that switch. Then check any of the others for loose connections. Normally an easy fix which is also covered under warranty being that it is only 2 years old.

Would love to read an intro post but only if you have time. Again, welcome aboard mate!

.

Welllll?!?!? Is it fixed? I haven't slept since thanksgiving worrying about this!